Most every home with particle board subflooring will need to have their subfloors replaced eventually.
Mobile home floor bowing.
Both of these materials used for flooring are much better in regards to water resistance.
A few years ago i replaced the insulation underneath my mobile home.
Subfloors are an important subject in the mobile home world.
Now a month later my floors are beginning to.
Because soil shifts and house frames settle there is usually a slight variation in floor level.
If you have a noticeable hump in the floor however something.
Since a mobile home is typically up on bricks or corner blocks there is a tendency for the floors to sag eventually.
You can have the entire unit raised and set back down on a solid flat foundation in which case you might as well buy a new house.
We lived in our home for 22 years and recently noticed a hump in a floor between the kitchen and the living room.
How to repair a hump in the floor.
However even homes with these newer flooring materials the floors can still bow soften and warp.
How to level sagging mobile home floors.
However keep in mind that you may need to just tighten the screws on your door hinges or check to see if the hinges are bent.
For instance more than one door will stick or swing or a window won t shut or latch properly.
How to fix bowed floors.
Hopefully this article will give you enough information to replace flooring in a mobile home yourself.
This week in our ask a mobile home expert series we are covering questions about mobile home subfloors.
If water has seeped into the boards they may swell against one another which can cause the bow.
I had a drain line burst under my home about a month ago though no water touched the insulation or floor boards as the line runs along the ground.
The home has a basement where we can see the floors and i cannot see anything.
Bowing or warping of floor boards can occur for several reasons.
The contractor told me all i needed to do was to staple the insulation to the floor joists so we did not replace the belly paper.
Normally when a home becomes unlevel you ll be able to find more than one tell tale sign.
Still if you have a soft spot or bowing in any area it s best to replace the subflooring in a mobile home quickly before it causes further damage.
Most older mobile homes consist of subflooring made from particle board which is extremely absorbent and susceptible to bowing warping rot and soft spots.
Newer mobile homes will have it a little better than older ones.
Newer homes are slightly better.
Newer mobile homes will either use a better particle board or oriented strand board osb.